14
Ignition/Operation
1. Ignition. After finishing the preparation, open the hot water outlet
valve; the water heater will make “pop” sound; then the hot water
will immediately flow out. If the water heater cannot be turned on
at once, close the hot water outlet valve; and restart the water
heater after 15 – 20 seconds.
2. Outlet Water Temperature Controller. Rotate the flame controller
knob to “Max” position or rotate the water volume controller knob
to “High” position, the outlet water temperature will increase. On
the contrary, rotate the flame controller knob to “Min” position or
rotate the water volume controller knob to “Low” position, and then
the outlet water temperature will decrease. If the temperature of
the supply water is 25
o
C, then the maximum temperature of hot
water that could be reached is 70
o
C.
When the gas controller knob is at “LOW”
position, the water controller knob is at
“HIGH” position, the output water
temperature reach the lowest scale.
Automatic
Ignition
When the gas controller knob is at
“HIGH”
position,
the
water
controller knob is at “LOW” position,
the output water temperature
reach the highest scale.
Open the hot water outlet valve, and the
water heater will ignite automatically
