Modern Flames Landscape Pro Multiview LPM-4216, Installation And Owner'S Manual

11

OPERATION

OPERATION

This will cycle the machine on and off. Upon cycling 

power on, the machine will return to the settings it had 

when it was cycled off.

If the fireplace is on, this button will act as a reset and 

bring all colors back to the default Modern Flames 

orange/yellow.

This will cycle the heater between high, low and off.

All zones of the fireplace will start the slow fade 

between colors.

Pressing the sync button will change all the colors of 

the fireplace) Flame, Ember Bed and Downlight) to 

match the current color of the flame setting.

This is a zone setting. Touching this button will allow 

you to change the color and brightness of the flame by 

using the RGB wheel and brightness slider.

This is a zone setting that controls the color and 

brightness of the ember bed.

This is a zone setting that controls the color and 

brightness of the downlight.

The unit has a main power switch just in front of the glass on the right hand side. A hand-held remote is 

included.

Power indicator lights for wall switch as well 

as upper right corner of the main unit

When the switch turns on, this orange pilot lamp 

turns on. It shows the fire is energized.

The status light above shows that the power is on 

and the heater is on low.

The status light above shows that the power is on 

and the heater is on high.

Pairing remote:

To pair remote, turn off the fire unit at the main power switch for 30 seconds. Hold the On/Off button on 

the remote while flipping the main power switch back to on. When the fire unit powers up, the remote will 

be paired.

Power

Reset

Heat

Fade

Sync

Flame

Ember 

Bed

Downlight

Manual Controls

The unit has manual controls located next to the 

power switch, just in front of the glass on the top 

right side.

Power

Turns unit 

on/off

Heat

Cycles 

heat low/

high/off

Color

Changes 

fireplace 

color

Reset

Resets 

unit