8
OPERATION
MAINTENANCE
Finger pull tabs
1. Remove the inner glass panel by first
removing the 2 screws in the finger pull tabs
(finger pull tabs are located on the top of the
glass panel.) Tilt the glass face down about
45 degrees and remove the glass. Store the
glass panel upright (not on it’s face) in a
safe place.
CAUTION
: There are locator pins on the
bottom of the glass panel. Tilt glass from top
and lift gently to avoid damaging the pins and
unit face.
Installing a fire feature (Canyon Juniper Log set, Crystal Glass Coal set)
Installing remote touch control
2. Follow the instructions included with the fire
feature.
1. Locate and remove the access door on the
rear right side of the fire unit.
2. Locate the remote touch control directly
inside the access panel. Pull the touch
control through the access panel and
replace the access door. Locate the touch
control anywhere within cable length.
3. Remove glass face (attached with magnets)
from touch assembly. Cut out drywall to
match orange bracket. Turn the 2 screws
visible in the face to secure the bracket to
the wall. Replace the glass face.
Touch control glass face
