8
OPERATION
Finger pull tabs
1. Remove the inner glass panel by first
removing the 2 screws in the finger pull tabs
(finger pull tabs are located on the top of the
glass panel.) Tilt the glass face down about
45 degrees and remove the glass. Store the
glass panel upright (not on it
’
s face) in a
safe place.
CAUTION
: There are locator pins on the
bottom of the glass panel. Lift gently to avoid
damaging the pins and unit face.
Installing a fire feature (Canyon Juniper Log set, Crystal Glass Coal set)
Installing remote touch control
2. Follow the instructions included with the fire
feature.
1. Locate and remove the access door on the
rear right side of the fire unit.
2. Locate the remote touch control directly
inside the access panel. Pull the touch
control through the access panel and
replace the access door. Locate the touch
control anywhere within cable length.
DO
NOT INCREASE LENGTH OF WIRES
CONNECTING TOUCH CONTROL TO
UNIT
.
3. Remove glass face (attached with magnets)
from touch assembly. Cut out drywall to
match orange bracket. Turn the 2 screws
visible in the face to secure the bracket to
the wall. Replace the glass face.
If you decide not to install the touch control
unit in the wall, IT IS IMPORTANT YOU
LEAVE THIS WIRED TO THE UNIT. Leave it
stored inside the compartment near the
terminal block where you originally found it.
This is important for severing the unit
should this piece fails.
Touch control glass face
