42
https://www.modernflames.com
Operation
– Important Warnings
Note:
When the heater is first turned on, a slight odor may be present. This is normal and should not occur
again unless the heater is not used for a long period of time.
To improve operation, aim the remote control at the front of the fireplace. Quickly pressing buttons on
the remote without allowing the fireplace to complete the previous operation may result in operational
errors. Allow the fireplace to complete each command before issuing another.
Remote Control Battery Information
•
Remote control uses one CR2032 battery (Included)
Temperature Limiting Control
This heater is equipped with a Temperature Limiting Control. Should the heater reach an unsafe
temperature, the heater will automatically turn Off.
To Reset:
•
Remove power from the fireplace. Wait 5 minutes.
o
Unplug the fireplace or turn off the appropriate breaker at the circuit breaker box.
•
Inspect the fireplace to ensure no vents are blocked or clogged with dust or lint. Using a vacuum
can help clear the areas if needed.
•
Apply power to the fireplace.
•
If problem continues, have the wiring and outlet inspected by a professional.
Care
– Cleaning
Metal
:
•
Clean using a soft cloth, slightly dampened with soapy water.
•
DO NOT use a brass polish or household cleaners as these products will damage the metal trim.
Glass
:
•
Use an ammonia-free glass cleaner sprayed onto a cloth or towel. Dry thoroughly with a paper towel or
lint-free cloth.
•
DO NOT use abrasive cleansers, liquid sprays, or any cleaner that could scratch the surface.
Vents
:
•
Use a vacuum or duster to remove dust and dirt from the heater and vent areas.
Plastic
:
•
Wipe gently with a slightly damp cloth and a mild solution of dish soap and warm water.
•
DO NOT use abrasive cleaners, liquid sprays, or any cleaner that could scratch the surface.
Never dispose of batteries in fire. Failure to observe this precaution
may result in an explosion. Dispose of batteries at your local
hazardous material processing center.
Always turn heater OFF and unplug power cord from the outlet before
cleaning, performing maintenance, or moving this fireplace. Failure to do so
could result in electric shock, fire, or personal injury.
Never immerse in water or spray with water. Doing so could result in electric
shock, fire, or personal injury.
