11
https://www.modernflames.com
Hardwiring Installation
If it is necessary to hardwire this appliance, a qualified electrician must remove the cord connection and
wire the appliance directly to the household wiring.
NOTE: A dedicated 20 Amp (or higher) breaker is required.
The appliance must be electrically connected and grounded in accordance with local codes. In the
absence of local codes, use the current CSA C22.1 Canadian Electrical Code in Canada or the current
ANSI/NFPA 70 National Electrical Code in the USA.
Note:
There are 3 wires from the appliance junction box: white (neutral), black (power L1), and green (ground) that
are connected to 120V power source (circuit breaker panel).
•
Remove the 3 securing screws from the junction box cover plate, located on the bottom left-hand,
back-side of the appliance (Fig. 4-1).
•
Install the strain relief to the junction box cover plate (located in hardware bag) (Fig. 4-2).
•
Separate the black, white, and green wires that have the wire nuts on them.
•
Remove all the wire nuts. Connect the green wire (
G
) to the supply ground wire, the white wire (
N
) to
the supply Neutral wire, and the black wire (
L
) to the supply L1 wire. (Fig. 4-3).
•
Resecure the junction box cover plate using the 3 screws previously removed.
