3
l
This product is
not intended
to be a
primary heat source.
It is for
supplemental heat only.
l
ALWAYS
disconnect
this unit from the
power
supply
before
performing any assembly or
cleaning, or before relocating the electric fireplace.
l
ALWAYS
store this heater in a dry location.
NEVER
use the fireplace if it has become wet.
l
NEVER
plug this heater into an outlet that is
old
,
cracked
, or has any
loose wires or
connections
. Plugging this heater into a faulty outlet could result in
electric
arcing
within the
outlet that could cause the
outlet
to
overheat or catch
fire
.
l
ALWAYS
check your heater cord and plug connections with
each use.
i)
MAKE SURE
the plug fits tight in the outlet. Faulty wall outlet connections or loose plugs can
cause the outlet to overheat.
ii)
Heaters draw more current
than small appliances.
Overheating
may occur even if it has
not occurred with the use of other appliances.
iii) During use
check frequently
to see if the
plug outlet or face plate
is
HOT.
iv) If the outlet or face plate is
HOT
,
discontinue use immediately
and have a qualified
electrician inspect and/or replace the faulty outlets.
l
SAVE THESE INSTRUCTIONS.
Preparation
This product includes a
GLASS panel.
Always use
extreme caution
when handling
glass.
Failure to do so could result in
personal injury
or
property damage
.
Due to the many different materials used on different walls, it is highly recommended that you consult
your local builder before you install this fireplace.
Remove all parts and hardware from the carton and place them on a clean, soft, dry surface. Parts and
assembly steps are grouped for wall-hanging or recessing use. Check the parts list to make sure
nothing is missing. Dispose of packaging materials properly. Please recycle whenever possible.
You will need the following tools (not included):
Phillips screwdriver, stud finder, level, tape
measure, electric drill, 1/4” (6.4mm) wood drill bit, hammer.
Summary of Contents for Redstone RS-2621-AU
Page 23: ...23 ...
