6
INSTALLATION
INSTALLATION
WARNING: If the information in these
instructions is not followed exactly, a
fi
re
or explosion may result causing property
damage, personal injury or death.
WARNING - RISK OF FIRE!
To prevent a possible
fi
re, do not block air
intake or exhaust in any manner. Do not
use on soft surfaces where openings may
become blocked.
WARNING - RISK OF FIRE!
Do not blow or place insulation against the
fi
rebox.
To reduce the risk of
fi
re do not store or
use gasoline or other
fl
ammable vapors in
the vicinity of this or any other heater.
CAUTION: Keep combustible materials,
such as furniture, pillows, bedding,
papers, clothes and curtains at least 3
feet (0.9m) from the front of the heater and
keep them away from the sides and rear.
CAUTION: Wear gloves and safety glasses
for protection during installation and
maintenance.
Installing
fi
replace
Select a suitable location that is not susceptible
to moisture and is a safe distance from drapes,
furniture and high tra
ffi
c areas.
A quali
fi
ed
electrician should add a dedicated
fl
exible
20 amp 120 volt circuit per local building
codes.
Note: Follow all national and local electrical
codes.
This
fi
replace has a number of installation options. It can be installed fully recessed, half recessed, wall
mounted with a
fl
oating cabinet or with a simple slide-in cabinet. In addition, the fully recessed option can
be installed with all sides showing, 1 side showing, or
fl
ush.
To prepare for installation, connect the hard wire to the terminal block located on top back right of
fi
replace according to the diagram below. Choose any connector type according to local building code.
To be performed by a quali
fi
ed electrician
according to local building codes.
L - Line
- Ground
N - Neutral
