12
OPERATION
OPERATION
This will cycle the machine on and off. Upon cycling power on, the
machine will return to the settings it had when it was cycled off.
If the fireplace is on, this button will act as a reset and bring all colors
back to the default Modern Flames' signature color.
This will cycle the heater between high, low and off.
All zones of the fireplace will cycle through various demo modes - 7 &
3 color gradient/fade, 7 & 3 color jump, red/green/blue gradient.
Pressing the sync button will change all the colors of the fireplace
(Flame, Ember Bed and Downlight) to match the current color of the
flame setting.
This is a zone setting. Touching this button will allow you to change
the color and brightness of the flame by using the color wheel and
brightness slider.
This is a zone setting that controls the color and brightness of the
ember bed.
This is a zone setting that controls the color and brightness of the
downlight.
This will cycle the selected zone through the colors of the color
spectrum.
This will adjust the brightness of the selected zone.
The fireplace has a main power switch just in front of the glass on the top right hand side.
A hand-held remote is included.
Power indicator lights for wall switch as well as
upper left corner of the main unit
When the switch turns on, this orange pilot lamp turns
on. It shows the fire is energized.
The status light above shows that the power is on and
the heater is on low.
The status light above shows that the power is on and
the heater is on high.
Pairing remote/wall mounted touch control:
1.
With the fireplace ON press and hold the Power button for about 3 seconds until you hear the buzzer sound
twice and the power indicators begin to flash.
2. Within 5 seconds on the hand held remote or wall touch control press the Power button repeatedly until the
buzzer sounds again and the indicators flash acknowledging that it has paired. You may also hear another
buzzer and the pair is now completed.
•
Pairing must be done within 5 seconds or the fireplace will time out of pairing mode.
•
To clear any paired remotes from the unit, locate then press and hold the reset button for 3 seconds. You
should hear a buzzer letting you know the codes have been cleared so you can now pair a new remote or wall
touch control. (The reset is located next to the manual controls and can be pressed with a paper clip.)
Power
Reset
Heat
Fade
Sync
Flame
Ember
Bed
Downlight
Manual Controls
The fireplace has manual controls located just in front
of the glass on the top left side.
Power
Turns unit
on/off
Heat
Cycles heat
low/high/off
Color
Changes
all fireplace
colors
together
Reset
Resets
fireplace
Color
Wheel
Brightness
Slider
