9
INSTALLATION
1. This installation is optimized for a 2"x6" (51mm X
152mm) framed wall. Prepare the framed opening
according to the height and width of the chart on
page 7. Provide a 13 amp (EU) or 10 amp (AU/
NZ) circuit for hard wire install at the top right of the
framed opening.
2. Install L Metal Mounting Brackets to the top and
bottom of the fireplace. Mounting holes located
approximately 8-3/4" (223mm) from front surface.
3.
Install the fire unit in the framed opening with a
minimum 1-1/4" (32mm) drywall screws to secure
the fireplace.
4.
Mask the exposed fireplace during this process.
Install drywall, tile or material of your choice to the
drywall stops on the perimeter of the fireplace. For
more information on the drywall stops see page 4.
5. Install log set and glacier crystals, see page 10.
6. Install the side and front glass pieces according to
installation diagram on Page 11.
PARTIAL RECESSED INSTALLATION