Wall mounted installation
Due to the many different materials used on different walls, it is highly recommended
that you consult your local builder before you install this appliance on the wall.
A.
NOTE: A dedicated 10 Amp (or higher) breaker is required.
B.
Select a location that is not prone to moisture and is located at least 36" (914mm)
away from combustible materials such as curtain drapes, furniture, bedding, paper,
etc.
C.
Have two people hold the appliance against the wall to determine the final
location.
D.
Place unit face down on a soft, non-abrasive surface. Remove the wall bracket
(
K
) from the back of the unit by removing the screws, refer to Figure 1.
E.
Mark location, then mount the bracket(s) onto the wall using the supplied screws.
This bracket MUST have the hooks facing upward and be level.
NOTE: It is
strongly recommended that the
mounting bracket (K) be
Screwed into the wall studs
where possible. If the wall
studs cannot be used, ensure
the supplied plastic anchors are used to affix the bracket to the wall and the
bracket is adequately secured.
F.
With the wall mounting bracket installed have two people lift the appliance up and
insert the two hooks on the bracket into the two slots on the back of the appliance.
G.
Check the appliance for stability ensuring that the bracket will not pull free from
the wall.
H.
Install the side skirt panels (
F
) to each side of firebox.
SPS-50/60/74B Wall Bracket Illustrated
10
Size
A
B
C
50”
11-1/2”
[292mm]
4-1/4”
[108mm]
9-5/8”
[244.5mm]
60”
8-1/4”
[209.5mm]
4-1/4”
[108mm]
9-5/8”
[244.5mm]
74”
15-1/8”
[384mm]
4-1/4”
[108mm]
9-5/8”
[244.5mm]
Summary of Contents for SPS-100B-AU
Page 19: ...19 Spare Parts List ...
