17
TEMP
1.
Press once:
Touch panel indicator becomes active.
2.
Press again
until desired temperature is reached. Digital display shows settings 0-10.
Table below shows corresponding temperatures:
NOTE:
Press the button for 5 seconds to switch between
°
C and
°
F
MEDIA
MEDIA BED button
: Turns on media bed
and changes color.
NOTE:
color effect stays on until power
button is turned off.
NOTE:
this fireplace has memory function
for ember bed.
1.
Press once:
Turns on ember bed.
2. Press again
until desired color is
reached. In total ten colors and one fade
mode.
01-02-03-04-05-06-07-08-09-10-11
MEDIA
BRIGHT-
NESS
MEDIA brightness button
: Makes media
bed dimmer and brighter.
NOTE: LED
MEDIA light brightness stays
on until power button is turned off.
1.
Press once:
Brightness becomes active.
2.
Press again
until desired setting is
reached. In total 5 levels.
From L5 - L4 - L3 - L2 - L1
Temperature Limiting Control
This heater is equipped with a Temperature Limiting Control. Should the heater reach an unsafe
temperature, the heater will automatically turn OFF. To reset:
1. Unplug the power cord from the outlet. Wait 5 minutes.
2. Inspect the fireplace to make sure no vents are blocked or clogged with dust or lint. If they are,
use a vacuum to clean the vent areas.
3. Plug the power cord back into the outlet.
4. If the problem continues, have your outlet and wiring inspected by a professional.
Remote Control Battery Information
•
Remote control uses one
CR2025
battery
(
Included
)
When the heater is first turned on, a slight odor may be present. This is normal and
should not occur again unless the heater is not used for a long period of time.
NOTICE
To improve operation,
aim
the remote control at the front of the fireplace.
DO NOT
press the buttons too quickly
. Give the unit time to respond to each command.
NOTICE
Summary of Contents for SPS-100B-AU
Page 19: ...19 Spare Parts List ...
