Modify EZ-1002FX, Operating Manual And User Manual

SETTING UP

SETTING UP

These channels allow you to plug digital keyboards, computers, sequencers and any other

stereo (2 ch.) devices. The same procedure as above is used to set up these channels.

The professional features of the Mini Mixer makes it easy to use and to tailor the sound of

your system.

Always make sure there is a good electrical ground. Before turning on the mini Mixer, be

sure that the power switch is in the off position, the volume controls are all the way down

(-

level) and all audio connections are made before switching the speaker on.

CONNECTIONS / WIRING

The mini Mixer input panel has one XLR plus one TRS connector for each of the mono

channels and TRS connectors in stereo Channels.  Be sure to use high quality shielded cable

and connectors.

Mono Channels:

Balanced XLR microphone and line inputs make it easy to plug microphones into the mixer.

Plug in your mics, making sure the output volume is Iow, PAN and all EQ controls are in the

center detent position, and all GAIN controls and all the way down.

For best results, the gain throughout the system should be matched from one device to the

next.

Follow these few steps and you are on your way to great sound!

Set the first channel LEVEL control in the "12 o'clock" position. All others are down (-

).

Speak into your mic (or start the CD player) and, watching the meters, slowly increase

the level using the GAIN control at the top of the channel. The meters should only ticker

on the CLIP (RED) LED.

Adjsut the EQ the way you like, keeping in mind that extreme EQ effects the output level.

If the CLIP LED glows, turn the GAIN control down (anti-clockwise) until the LED just

flickers.

Repeat for each channel used.

Adjust the MAIN MIX control so that the CLIP LED is only on a very short time-NEVER

ON SOLID.

The gain of the next device, usually an amplifier just night be very Iow. This is OK as it is

getting the cleanest, strongest signal from the mixer.

If you are using a Graphic EQ, follow the same steps to set up the GAIN from the mixer

to the EQ to the amplifier.

Stereo Channels:

OPERATING MANUAL AND USER GUIDE

OPERATING MANUAL AND USER GUIDE

11