S
S
e
e
t
t
t
t
i
i
n
n
g
g
s
s
After everything is connected properly, plug in the AC power cord to the power outlet. If the player is
correctly connected to your system, MODIX logo appears on your TV, when you turn on the Player.
If the ModiX logo does not appear and Picture is distorted, when you start the Player, Please check as
follows;
①
Recheck the cable connections. Try connecting your TV set using the Composite Video cables.
Composite Video always produces a picture
②
Set your TV at A/V mode. Refer to the equipment owner’s manual for detail.
③
Make sure your TV set support progressive video input before setting this player to progressive
mode. Otherwise, a black screen will be shown on your TV.
At this time, press (N/P) button repeatedly
until you see the
normal screen.
You can always access the SETUP menu and adjust the MODIX
to your specific requirements and hardware. When MODIX
appears on the main screen, press the SETUP button and a
menu will appear with the available options.
Note:
Use the arrow buttons on the remote control to move the rectangular frame to the language you wish to
select and press ENTER.and if you press SETUP again, the setup will be saved.
1
1
.
.
V
V
i
i
d
d
e
e
o
o
S
S
e
e
t
t
t
t
i
i
n
n
g
g
The Player can be connected in different ways -Composite, S-Video, Component, HD-Component. You
only need to select one video connection from the following options. The connection depends on the
outlets available on your TV and the capabilities of your TV system.
If your TV
’
s :
Picture is distorted.
Picture is black and white only.
Picture is not full screen, or part of the border is not visible.
Setup the video output setting correctly.
Note :
Make sure your TV set must support progressive video input before setting this player to progressive mode. Otherwise,
a blank screen will show on your TV. Press (N/P) button repeatedly to show the normal screen by this time until you
see the menu again.
Progressive Scan is available and requires a special type of cable and a special TV set.
After connecting to 1080i mode, screen flicking is a normal thing and interlaced mode is suitable for
moving picture not for documentation and graphic works
