2.3.7 Partial delete
This option is only available in Vending mode. It only deletes the displayed entry.
The total input is never completely erased.
2.3.8 Reset parameter
This option is only available in Vending mode. It loads the factory setting and resets
all counters except the total number of coffees, the total revenue and the total of
servings.
2.3.9 Time setting
This option allows you to set the time on the main display.
While the machine is turned off, the clock does not work, and the time
must be reset.
2.3.10 Maintenance
With this option, you can set after how many servings of coffee the machine
displays due maintenance checks and reset each counter individually
(For example, to show, if only one grinder has been serviced).
The machine continues to function normally while displaying the maintenance check
and keeps showing the warning until it is serviced.
2.3.11 Waiting time
This option is only available in “2C” mode (2 Quality levels). This allows you to set
the waiting time after the first use of the cutter mill, to activate the extra serving.
The default time is 3 seconds and can be changed by tenths of a second.
2.4 Coin selector
There are two options: with and without warning. The selector with warning controls
the rejection of invalid coins by software and is usually used by MODO selectors.
The selector without warning rejects invalid coins by a switch directly on the selector.
The MODO selector is configured in this mode.
By default, the circuit works with the selector in NRI. To change the mode proceed
as follows:
1
Turn off the machine.
2
Press and hold the S1 button (or the J11 connector) and turn the power on.
page 5