Modular FU 110/40 FRGS13 PW Installation - Use - Maintenance Download

Page: 9 / 132

- Convert the appliance to the local gas type, if

necessary. Follow the instructions at the next
paragraph “Conversion to a different type of gas”.

- On top appliances a rear connection is also

available. Remove the plug present and screw it
tightly onto the front connector.

- A rapid-action gas shut-off valve must be fitted

upstream of the appliance in an easily accessible
position.

- Do not use connection pipes having a diameter

smaller than that of the appliance's gas
connector.

- Once the appliance has been installed, check for

gas leaks at the connection points.

ELECTRICAL CONNECTIONS

- Check if the appliance is designed to operate at

the voltage and frequency of the power supply
present on site. Check the details given on the
appliance dataplate and plaque near the terminal
board.

- Install upstream of the equipment in an easily

accessible place, an all-pole disconnecting device
with a contact gap of allowing full disconnection
under the conditions of overvoltage category III.

- A flexible rubber cable with insulation

specifications not lower than type H05 RN-F must
be used for connection.

- Connect the power supply cable to the terminal

board as shown in the wiring diagram supplied
with the appliance.

- Secure the power supply cable with the cable

clamp.

- Protect the power supply cable on the outside of

the appliance with a rigid plastic or metal pipe.

- If the power supply cable is damaged, it must be

replaced by the manufacturer or his service
centre or by a person with similar qualifications
to prevent any risk.

THE SYMBOL “ HIGH VOLTAGE” IS
PLACED ON A PANEL THAT GIVES
ACCESS TO A PART WITH HIGH
VOLTAGE.

PROTECTIVE EARTH AND EARTH BONDING
CONNECTIONS

Connect the appliance to an efficient ground
circuit. Connect the earth conductor to the

terminal with the symbol

next to the main

terminal board.

Connect the metal structure of the appliance to
the equipotential node. Connect the conductor to

the terminal with the symbol

on the outside

part of the bottom.

CONNECTION TO THE WATER SUPPLY

- The appliance must be connected to a potable

water supply. The water inlet pressure must be
between 150 kPa and 300 kPa. Use a pressure
reducer if the inlet pressure is above the
maximum permitted level.

- Install a mechanical filter and a shut-off valve

upstream of the appliance in an easily accessible
point.

- Make sure the water circuit is free of ferrous

particles before connecting the filter and the
appliance.

- Seal any unused connectors with a plug.
- Once the appliance has been installed, check for

gas leaks at the connection points.

CONNECTION TO THE WATER DRAIN

The water drainage system must be made using
materials resistant to temperatures of 100 °C. The
bottom of the appliance must not be subjected to
steam produced by drainage of hot water.

Install a siphoned floor drain with grating below
the water drain cock of Boiling pans and in front
of Bratt pans.

CONVERSION TO ANOTHER
TYPE OF GAS

Table Tab1 specifies:

- which gas can be used for the appliance.
- the nozzles and settings for each gas that can be

used.

- For nozzles, the number indicated in table TAB1 is

also stamped on the body of nozzles.

- To convert the appliance to the local gas type,

follow the instructions given in TAB1 andcarry out
the steps below:

- Replace the main burner nozzle (UM).
- Adjust the main burner's air regulator to distance

-  Replace the pilot burner nozzle (UP).
-  Adjust the pilot burner air " ow (if necessary).
-  Replace the gas valve minimum nozzle (Um).