Rinse dispenser tube and wipe with a non-toxic cleaner/sanitizer.
Remove clamp ring (1), gasket (2), pusher (3), and spring (4).
Remove dispenser from mounting location.
Your Modular SIMPLI-FLEX dispenser is designed to provide
CLEANING THE DISPENSER:
an easy means of dispensing. The dispenser can be disassembled
without tools to make regular cleaning simple!
the life of the dispenser, keep it looking new and ensure sanitary
dispensing.
Clean clamp ring and gasket in hot, soapy water. Air dry.
NOTE: these parts are dishwasher safe.
Reassemble dispenser in reverse of above.
(See Figure 1)
Please clean dispenser before use. Regular cleaning will prolong
13700 Broadway Ave.
Phone: 216/587-3400
Fax: 216/587-0733
www.tomlinsonind.com
Cleveland Ohio 44125-1992
Tomlinson Industries 2000
a
b
LOADING THE DISPENSER:
Your Modular SIMPLI-FLEX dispenser is completely self-adjusting.
PORTION CUP DISPENSER
(See Figure 2)
Unwrap cups and gently push into completely assembled dispenser tube.
IMPLI
1.
S
b
3.
5.
4.
LEX SFP2000
F
-
b
1.
2.
b
NOTE: CAUTION when removing gasket, pusher may be under small amount of spring tension.
Remove pusher from spring.
Remove spring from dispenser.
4.
3.
Peel off gasket from lip of dispenser.
Remove decorative clamp ring.
DISASSEMBLY: (Refer to Figure #1)
1.
2.
4-11/16 (119.05mm)
3-3/4 (95.25mm)
3-5/8 (92.08mm)
14.00 (355.6mm)
D
A
B
C
MOUNTING HOLE
DIAMETER
EASE OF INSTALLATION AND SERVICE. ALLOW AT LEAST
1/4" (6.35 mm) BETWEEN DISPENSERS (DIMENSION "A")
Reassemble dispenser.
hole and secure through keyhole slots with screws provided.
Pre-drill holes for #8 x 3/4" mounting screws (6). Slide dispenser into
Remove clamp ring (1), gasket (2), pusher (3), and spring (4). (See Figure 1)
Lay out and cut hole(s) for dispenser.
4.
3.
2.
1.
REFER TO CHART AND DIAGRAM TO ESTABLISH
MOUNTING HOLE SIZE AND MINIMUM CLEARANCE FOR
FOR IN-COUNTER MOUNTING:
INCHES (METRIC)
SFP2000
b
REFERENCE DIMENSIONS
