MOD-6182 / MOD-6183 / MOD-6185 / MOD-6186 HEADBOARD
Customer Service 609-256-9000︱www.modway.com
Page 4 of 6
Note:
Extra hardware were provided for attaching the headboard to your Bed Frame (use is optional).
STEP 1:
1. Line up the
Bed Frame (2)
board’s pre-drilled holes to match the
Headboard (1)
post’s Internal or external
hole (
Noted:
Full size Bed Frame match the Headboard post’s internal hole as shown with
Figure 1
and
Queen size Bed Frame match Headboard post’s external hole as shown with
Figure 2
.)
2. Secure the
Headboard (1)
to the
Bed Frame (2)
by using 2 pieces of
Bolts (B)
for the thicker
Bed Frame (2)
, and 2 pieces of
Bolts (A)
for the thinner
Bed Frame (2)
.
3. Before inserting each bolt, place 1 piece of
Spring Washer (D)
and
Flat Washer (C)
on each bolt. Then
Fit 1 piece of
Flat Washer (C)
and
Nut (E)
on the bolt as it protrudes through the
Bed Frame (2)
and the
Headboard (1)
as shown.
4. Repeat the same procedure for each bolt and each side of the
Bed Frame (2)
.
5. Use
Allen Wrench (F)
and
Spanner Wrench (G)
to tighten all
Bolts (A or B)
and
Nut (E)
clockwise as shown.
STEP 2:
Carefully position the assembled bed to the desired location by four adults.
Assembly is completed. The bed is ready to use now!
NOTE:
Hardware may loosen over time. Periodically check that all connections are tight.
