Customer Service 908-368-1025
︱
︱
︱
︱
www.modwayfurniture.com Page 2 of 4
EEI -1215
BOOKSHELF
Ax20
Bx20
Dx1
STEP 1:
Hardware & Tool required
STEP 2:
Please put the Left Frame (1) and the Middle Frame (2) on a carpeted or padded surface as shown below.
Note: The back of each shelving unit is the end with five sets of pre-drilled holes. These holes were drilled to affix the 5pcs
Back Rails (4).
Insert 2pcs Bolts (A) into the pre-drilled holes on the back of the Left Frame (1) and Middle Frame (2) through the pre-drilled
holes on the Back Rail (4) as shown.
Use 2pcs Nuts (B) with the 2pcs Bolts (A) to attach the Left Frame (1) and Middle Frame (2) as shown.
Tighten the Bolts (A) and Nut (B) by hand at first, then use Allen Wrench (D) to tighten the Bolts (A) clockwise until secure
.
Repeat the above steps for affixing the Right Frame (3) to Middle Frame (2) and the remaining 4pcs Back Rails(4).
Ax24
Cx24
Dx1
Hardware & Tool required
Insert 8pcs Bolts (A) into the pre-drilled holes on the front of Left Frame (1), Right Frame (3) and Middle Frame (2) through
the pre-drilled holes on the Front Rail (5) as shown.
Use 8pcs Nuts (B) with the 2pcs Bolts (A) to attach the Left Frame (1) and Middle Frame (2) as shown.
Tighten the Bolts (A) and Nut (B) by hand at first, then use Allen Wrench (D) to tighten the Bolts (A) clockwise until secure
.
Repeat the same steps for affixing the Central Rail (6) and the other Front Rail (5).
Front
Back
