Customer Service 908-368-1025
︱
www.modwayfurniture.com
Page 2 of 2
EEI-2256
BAR TABLE
STEP 1:
Remove the plastic covers which pre-install in the end of the
Table Top (1)
by using
Allen Wrench (C)
.
Please Stand 1 piece of
Leg (2)
on a carpeted or padded area.
Insert 1piece of
Table Top (1)
and 2 pieces of
Bottom Stretcher (3)
to the
leg (2)
as shown.
Insert 4 pieces of
Bolt (A)
from the pre-drilled holes on the bottom of the
Table Top (1)
into
each side on the bottom of
Leg (2)
.
Insert 2 pieces of
Bolt (B)
from the pre-drilled holes on the side rail of the
Table Top (1)
into
each end of
Leg (2)
as shown.
Insert 8 pieces of
Bolt (A)
from the pre-drilled holes on the side of the
Table Top (1)
and
Bottom Stretcher (3)
into
the
Leg (2)
as shown.
Do not fully tighten
Bolt (A&B)
at this step.
Repeat the same steps for the remaining 1 piece of
Leg (2).
Use
Allen Wrench (C)
to tighten all
Bolts (A&B)
clockwise until secure
.
Assembly is completed. The table is ready to enjoy now!
Ax20
Bx4
Cx1
Hardware & Tool required
STEP 2:
Carefully turn over the assembled table.
B
C
A
C
A
C
A
A
C
C
A
A
The bottom of table top and legs
2
2
3
3
1
2
1
The bottom of table top and legs
The bottom of table top and legs
3
2
1
