Customer Service 908-368-1025
︱
www.modwayfurniture.com
Page 2 of 2
EEI-2266
ARM CHAIR
STEP 1:
Remove the plastic covers which pre-install in the end of the
Seat Frame (4)
by using
Allen Wrench (C)
.
Please put
Left
Leg (2)
on a carpeted or padded area.
Insert
Top Rail (1)
and
Seat Frame (4)
into
Left Leg (2)
as shown.
Insert 3 pieces of
Bolt (B)
from the pre-drilled holes on the bottom of the
Top Rail (1)
and
Seat Frame (4)
into
each side
on the bottom of
Left Leg (2)
.
Insert 2 pieces of
Bolt (A)
from the pre-drilled holes on the side rail of the
Seat Frame (4)
into
each end of
Left Leg (2)
as shown.
Do not fully tighten
Bolts (A&B)
at this step.
Repeat the same steps for
Right
Leg (3).
After checking the leveling for all connections,
please use
Allen Wrench (C)
to tighten all
Bolts (A&B)
clockwise until secure.
Ax4
Bx6
Cx1
Hardware & Tool required
STEP 2:
Assembly is completed. The chair is ready to enjoy now!
Carefully place the assembled chair at your desired location.
Put the
Seat Cushion (5)
and
Back Cushion (6)
to assembled loveseat frame as shown.
1
C
A
2
4
2
B
2
The bottom of seat frame and legs
The bottom of seat frame and legs
The bottom of top rail and legs
3
4
2
1
4
B
C
C
5
6
