Customer Service 908-368-1025
︱
www.modwayfurniture.com
Page 2 of 3
EEI–2323
BENCH
STEP 1:
STEP 2:
Hardware & Tool required
Put
Bench Body (2)
on a carpeted or padded area.
Position 1 piece of
Bench Leg (2)
to the apron inside without wooden block at first.
Attach by using 3 pieces of
Short
Bolt (A),
3 pieces of
Spring Washer (C)
and 3 pieces of
Flat Washer (D)
as shown.
Then position another pieces of
Bench Leg (2)
to the apron inside with wooden block.
Attach by using 3 pieces of
Short Bolt (A),
3 pieces of
Spring Washer (C)
and 3 pieces of
Flat Washer (D)
as shown.
Repeat the same steps for the remaining
Bench legs (2)
to the other side of
Bench Body (1)
.
Do not fully tighten the
Short Bolts (A)
at this step.
Ax12
Dx12
Dx12
F
E
B
A
Hardware & Tool required
Bx2
Dx2
Ex2
Fx1
Position
Middle Rail (3)
to the assembled
Bench Legs (2)
as shown.
Attach by using 2 pieces of
Long Bolt (B),
2 pieces of
Spring Washer (D)
and 2 pieces of
Plastic Washer (E)
.
Use
Allen Wrench (F)
to tighten all the
Bolts (A&B)
clockwise until secure at this step.
Assemble this leg at first.
C
1
A
C
D
2
2
2
2
D
E
D
B
D
F
