background image

Customer Service 908-368-1025

www.modwayfurniture.com

Page 1 of 4

EEI

 

–2

772

/2653

 

OFFICE CHAIR

Hardware:

Component:

Thank you for purchasing the

MODWAY OFFICE CHAIR

Before you start, here is some helpful advice:
1

.

We suggest you spend a short time reading through this leaflet and then follow the simple step by step

instructions.

2

.

Owing to the size and weight of the 

offi

ce chair, we recommend that it is assembled by two adults, on a carpeted

or padded area, in the room that it is intended for. Approximate assembly time: 15 minutes.

3

.

Please do not use any tools other than those provided or recommended in these instructions.

4

.

Please do not throw away any of the packaging or instructions until you have checked all the components and

hardware and the furniture is fully assembled.

5

.

Assemble all components loosely until advised to tighten. Depending on use, it may be necessary to tighten the

components from time to time, so please save the tools that have been provided.

6

.

Please keep all pieces out of reach of small children.

1

2

3

Bolt    M8*25mm

Bolt    M8*30mm

Flat Washer  8*17mm

4

H

    Castors 

X5

H

E

B

C

A

B

   

Right

 Armrest 

F

   Cylinder 

X1

A

   Chair Back 

X1

E

   Control Mechanism 

X3

X8

X7

Allen Wrench

X1

C

   

Left

 Armrest 

G

   

Chair Base

  

X

1

X

1

X

1

X1

D

   

Chair Seat

X

1

D

F

H

H

H

H

G

Summary of Contents for EEI-2772

Page 1: ...lease do not use any tools other than those provided or recommended in these instructions 4 Please do not throw away any of the packaging or instructions until you have checked all the components and hardware and the furniture is fully assembled 5 Assemble all components loosely until advised to tighten Depending on use it may be necessary to tighten the components from time to time so please save...

Page 2: ...G upside down on a carpeted or padded surface Insert 1pc of Castor H into the Chair Base G as shown by hand Repeat the same steps for the remaining 4pcs of Castor H STEP 2 Flip the assembled Chair Base G with Castors H on the floor Insert the bottom end of Cylinder F into the assembled Chair Base G as shown H H H H H G G F ...

Page 3: ...of Flat Washer 2 as shown Use Allen Wrench 4 to tighten all Bolts 1 and Bolts 2 clockwise until secure 1 2 3 4 1x1pcs 2x2pcs 3x3pcs 4x1pcs Hardware Tool required STEP 3 Please put the Chair Seat D upside down on a carton Attach Chair Right Armrest B and Left Armrest C into the bottom of Chair Seat D by using 4 pieces of Bolt 2 as shown Use Allen Wrench 4 to tighten all Bolts 2 clockwise until secu...

Page 4: ... of assembled Cylinder F as shown Sit on Chair Seat D to fully tighten the office chair STEP 5 Please put the assembled Chair Seat D upside down on a carton Attach Control Mechanism E into the bottom of Chair Seat D by using 2 pieces of Bolt 1 and 2 pieces of Bolt 2 with 4 pieces of Flat Washer 2 as shown Use Allen Wrench 4 to tighten all Bolts 1 and Bolts 2 clockwise until secure Assembly is comp...

Reviews: