Place
Center Rail (7)
and
4 pieces of
Support Leg (6)
under assembled
Double Slat (4)
and
Single Slat (5)
as shown.
Insert 4 pieces of
Long Bolt (C)
into the 4 holes right on
Center Rail (7)
to connect it with
Support Legs (6)
as shown.
Insert 4 pieces of
Medium Bolt (B)
into 4 other holes left on
Center Rail(7)
to connect it with
Support Legs (6)
as shown.
Secure the above 8 pieces of
Bolts (B&C)
with
Nuts (E)
from the bottom of
Support Legs (6)
at same time.
Use
Allen Wrench (G)
and
Open Wrench (H)
to tighten all
Bolts (B&C)
and
Nuts (E)
until secure
.
5478
Take out all
Double Slats (4), Single Slats(5)
and
Side Rails(3)
and place them as shown.
Insert one end of
Single Slats (5)
into
Rubber Insert (F)
, then insert them into the corresponding holes on one piece of
Side Rail (3)
as shown.
Attach
Double Slats (4)
to the same
Side Rail (3)
by using
Short Bolts (A)
.
Do not fully tighten
Short Bolts (A)
with
Allen Wrench (G)
yet.
Repeat above for the other
Side Rail (3).
Use
Allen Wrench (G)
to tighten all
Short Bolts (A)
clockwise until secure.
i
i
