Page 2/2
Ax4
Bx4
Cx1
Hardware & Tool required
STEP 1:
Place
Headboard (1)
and
Leg (2)
on a carpeted or padded area as shown. Attach
Legs (2)
into
Headboard (1)
by
inserting
Flat Washer (B)
and
JCBB 45mm
Bolt (A)
into the holes on the back of
Leg (2)
and
Headboard (1).
Tighten with
Allen Wrench (C).
STEP 2
:
1. Line up the bed frame board's pre-drilled holes to match those of the headboard.
2. Secure the headboard to the bed frame by using
JCBB bolt 60mm
(E)
for the thicker bed
frame, and
JCBB bolt 45mm
(D)
for the thinner bed frame. Before inserting each bolt, place
Spring washer (G)
and
Flat washer (F)
on each
bolt. Then fit a
Flat washer (F)
on the screw as it protrudes through the other side of the bed frame.
3. Place a
Hex nut (H)
after the
Flat washer (F)
at the end of each screw. Then tighten by using the
M5 Allen key (C)
and hold the
Hex nut
(H)
by using
Spanner (I)
.
4) Repeat the same procedure for each screw and each side of the bed frame.
Assembly is completed. The bed is ready to enjoy now!
Hx4
Ix1
Cx1
12.8
Fx8
Dx4 / Ex4
Gx4
Hardware & Tool required
Hx4
Ix1
Cx1
12.8
Fx8
Customer Service 908-368-1025 www.modwayfurniture.com
MOD 6095, MOD 6096
