5
INS10634C - 11/18
Undercounter Installation
复位键
电源指示灯
测试键
温馨提示：
此插头为漏电保护插头。正常运行时电源指示灯显
示红色。若毛巾架体出现漏电或外部电压短时间变
化过大，会导致跳脱。指示灯熄灭，产品断电。
此时，需按复位键进行复位。复位后指示灯保持正
常亮起，产品恢复正常使用。
注意：若多次复位均还是跳脱，请联系我们进行维
修。安全起见，建议每月按压一次测试键观察电源
指示灯是否正常熄灭，以确保漏电保护功能良好。
Tips:
This plug is for leakage protection. It’s power
indicator is displayed red during normal operation.
But if towel rack body has a leakage or the external
voltage changes too much in a short time, it may
cause tripping. The indicator will go out and the
product will be powered off.
You need to press the reset button to reset it. After
reset, the indicator is red again and the product
works normally.
Note: If multiple resets still cannot avoid tripping,
please contact us. For safety, it is recommended
to press the test button once a month to check if
the power indicator is off, to ensure the leakage
protection works well.
Reset button
Power
indicator
Test
button
Undercounter Installation
控制面板操作
开关指示灯
总开关 定时指示灯 定时开关
•
电源开关
：按下电源开关，开关指示灯亮，毛
巾架进入常开加热模式。
•
定时开关
：开关为循环切换模式，4h/2h循环选
择；切换至4h模式时，4h定时指示灯亮，产品加
热4小时后，电源自动关闭，加热停止；切换至2h
模式时，2h定时指示灯亮，产品加热2h后，电源
自动关闭，加热停止。
•
开关具有温控功能，温控范围45~55℃，可防止
温度过高导致烫伤。
Panel Operation Instructions
Switch indicator
Master
switch
Timing
indicator
Timing
switch
•
Power switch
: Press the power switch, the switch
indicator light is on, the towel rack enters the
heating mode.
•
Timing switch
: The switch is in cycle switching
mode. It has 4h/2h cycle selection. When selecting
4h mode, the 4h timing indicator light is on. After
the product is heated for 4 hours, the power is
automatically turned off and the heating stops.
When selecting 2h mode, the 2h timing indicator
light is on. After the product is heated for 2h, the
power is automatically turned off and heating stops.
• The switch has a temperature control function,
the temperature control range is 45
℃
~55
℃
, which
can prevent the temperature from being too high
and cause scald.
Undercounter Installation
Undercounter Installation
