7
2. 连接电源线
Connect the Power Cord
安装使用废弃食物处理器，需要您在厨房改造中
预留电源插座及开关。
提示：插座电路中要求有良好接地，必须有漏电
保护装置！在安装前，请不要将电源连接到处理
器上，请将电源关闭或拿掉保险丝。
如果电源软线损坏，为了避免危险，必须由制造
商、其维修部或类似部门的专业人员更换。
To install and use waste food processors, you
need to reserve power sockets and switches in
the kitchen renovation.
Tip: A good grounding is required in the socket
circuit, and there must be a leakage pro- tection
device! Before installation, please do not connect
the power supply to the processor, turn off the
power supply or remove the fuse.
If the power cord is damaged, in order to avoid
danger, it must be replaced by professionals from
the manufacturer, its maintenance deparment or
similar departments.
Please note: The operating voltage of this waste
food disposer has been marked on the bottom
cover of the disposer,other relevant information is
also present on the nameplate label on the
bottom cover.
A. This processor only uses AC power.
B. The processor power connection adopts the
plug connection method. This is recommended to
the processor for safety and ease of operation.
请注意：本废弃食物处理器的使用电压已标明在
处理器底部盖板上。同时底盖铭牌 标签上还标明
了其它相关信息。
A. 本处理器仅使用交流电。
B. 处理器电源连接采用插头的连接方式。为了安
全和操作方便建议给处理器。
6
5
G
将卡箍
(I)
装入法兰
(C)
的卡槽内。
Install the clamp
(I)
into the groove of the flange
(C)
.
用起子将螺丝
(G)
锁紧。
Tighten the screw
(G)
with a screwdriver
I
G
F
Summary of Contents for MEX50MCL
Page 13: ...13 B A 30 A B...
