MoJack 750XT Lift
18
STEP 22
Raising the MoJack 750XT with a power drill
(optional)
• The MoJack 750XT can be raised or lowered by using a
variable speed corded drill (7 amp minimum) or variable
speed cordless drill (18V minimum).
• The drill will require a 3/8” square driver (not provided).
• Remove Crank Handle by taking out the nut and bolt
which reveals the 3/8” Square Receiver.
• Firmly insert the 3/8” driver in the Square Receiver.
Rotate the drill forward (clockwise) to raise
the Lift Arm and rotate the drill in reverse
(counterclockwise) to lower the Lift Arm.
•
Carrier Locking Pin must be pulled out when
lowering until it clears the bottom Safety Hole.
• Follow all other operating instructions while using the
drill attachment.
• Replace the Crank Handle for future use.
Operator must have a firm grip on the drill before
raising or lowering the Lift Arm.
3/8”
Square
Driver
Square
Receiver
Screw
Thread
STEP 21
THE MOJACK 750XT IS NOW READY FOR STORAGE OR TRANSPORT.
Folding the MoJack 750XT
• Pull locking pin out to unlock.
• Raise the Tower out of the Base by pulling up on the
Grip Handle and then lower the Tower.
• The tower will be securely locked in place when the
locking pin retracts.
Tower Locking Pin
(unlocked position)
Lift Tower
out of Base
Tower Locking
Pin
(locked position)
