17
MoJack EZ Max Lift
Square Driver not included
Nylock
Lock-
ing
Nut
Spring
Crank
Handle
Before using a drill,
remove the Crank
Handle
Raising the lift with a power drill
(optional – power drill not included)
The lift can be raised or lowered by using a variable
speed corded drill (7 amp minimum) or variable speed
cordless drill (18V minimum). The drill will require a 3/8”
square driver (not included).
• Remove Crank Handle by taking off the Nylon Lock
Nut and Spring using 13mm wrench.
After Crank Handle removal, re-attach Spring and
Nylon Lock Nut to Crank Handle to prevent loss.
• Firmly insert the 3/8” square driver in the Square
Receiver. Rotate the drill forward (clockwise) to raise
the Lift Arm and rotate the drill in reverse (counter-
clockwise) to lower the Lift Arm.
•
Carrier Locking Handle must be manually pulled out when lowering
until it clears the bottom Tower Hole.
NOTE:
Crank Handle must be removed in order to use the drill attachment.
Follow all other operating instructions while using the drill attachment.
Replace the Crank Handle as necessary for future use.
NOTE:
When re-assembling handle, take care not to over-tighten the
Nylon Lock Nut against the spring. There should be enough free space
for the handle to be pushed in to move from storage position to operating
position.
NOTE:
When re-assembling the handle, a “popping” sound may occur
due to the re-engagement of the clutch system.
Operating Instructions
STEP 15
Operator must have a firm grip on the drill before raising or
lowering the Lift Arm.
3/8”
Square
Driver
Square
Receiver
STEP 14
Removing the Mower from the lift
• Remove the Safety Straps from front mower tires.
• Drive or roll the mower off of the Wheel Pads.
Make sure drill is
fully charged and
set at highest
torque.
Summary of Contents for EZ Max 45001
Page 44: ......