5.4 Other Plate Setting Tabs
If one plate or two plates are configured then a Plate Settings tab is added to
the HMI for each plate.
If Master/Slave configuration is selected then one Master/Slave Settings tab
is added. Settings are applied to both the Master (Plate #1) and Slave (Plate
#2).
5-7
SETUP
E-Drive Controller User Manual (with Pendant HMI)
© 2020 Mold-Masters (2007) Limited. All Rights Reserved.
Summary of Contents for E-Drive Series
Page 1: ...version 3 User Manual with Pendant HMI Original Instructions ...
Page 2: ......
Page 26: ......
Page 36: ......