Chapter 6: Defining a Wash or Rinse Cycle
5032022 C
73
Select the Wash Mode for the Cycle
Select either the
Bottom
or
Overflow
wash mode for the cycle.
The
Bottom
wash mode places the needles on the manifold in the well to the position
defined for the microplate type. During the wash cycle, only the bottom of the well is
washed.
The
Overflow
wash mode places the needles on the manifold above the well to the
position defined for the microplate type. During the wash cycle, the entire well is
washed. The wash solution is aspirated only after it reaches the aspiration needles on
the manifold.
When using the
Overflow
wash mode, Molecular Devices recommends that you use a
dispense volume that is slightly more than the well volume.
For information on defining the
Bottom
and
Overflow
positions for a microplate, see
Defining a Microplate Type on page 77
.
Figure 6-8: The Wash Mode prompt
Button
Action
On the left
Press this button to return to the previous step. See
.
On the right
Press this button to end the process and return to
Define Cycle
without saving any
changes. See
Defining a Wash or Rinse Cycle on page 65
Press this button to display either
Bottom
or
Overflow
wash mode.
Press this button to display either
Bottom
or
Overflow
wash mode.
Press this button to confirm the selection and then define the microplate shake time
for the cycle. See
Define the Microplate Shake Time for the Cycle on page 74
.
Table 6-8: Actions of Control Panel Buttons
Summary of Contents for MultiWash+
