Extractor Tool for Crimp Terminals
Doc No: ATS-638132700
Release Date: 11-07-07
UNCONTROLLED COPY
Page 3 of 7
Revision M
Revision Date: 09-01-09
Figure 5
PUSH IN THE
TERMINAL AND WIRE
HOUSING
HOUSING LOCK
PUSHED DOWN
EXTRACTOR
TOOL
WIRE
PROTRUDING TIP
OF HOUSING TANG
EXTRACTOR TOOL
HOUSING
Figure 4
For 35477 Terminal Series:
1.
Push the terminal and the wire forward in the arrow
direction before using this Tool.
2.
Insert the Tool into the slot above the locking tang of
the terminal.
3.
Push the tool down until the locking tang is even with
the rest of the terminal. This will free the terminal
from the housing.
4.
Pull the crimp wire back through the connector slot in
the arrow direction as shown in Figure 3.
For 35725 Terminal Series:
1.
Push the terminal and the wire forward into the housing before using this Tool.
2.
Insert the Tool into the area above the terminal contact and below the protruding tip of the terminal locking
tang in the housing.
3.
Lift the locking tab upward until it is above the contact of the terminal. This will free the terminal from the
housing.
4.
Pull the crimped wire and terminal back through the connector slot in the arrow direction as shown in Figure 4.
For 35768 Terminal Series:
1.
Push the wire and the terminal
forward in the arrow direction
before using the Extractor Tool.
2.
Insert the Extractor Tool into
the slot on the side of the
connector housing.
3.
While depressing the housing
lock, push the terminal back
through the connector slot and
pull the terminated wire out in
the arrow direction.
See Figure 5.
Figure 3
EXTRACTOR
TOOL
HOUSING
TERMINAL
LOCKING
TANG
PUSHED UP
PUSH IN
TERMINAL
AND WIRE
