Battery Powered Crimping Tool
Order No: TM-638161000
Release Date: 04-03-13
UNCONTROLLED COPY
Page 10 of 21
Revision: D
Revision Date: 12-16-15
2.1 Set-Up
Installing the Crimp Head
WARNING
: Remove the battery from the crimping tool before installing and removing the crimp head.
CAUTION:
Do not try to remove the crimp head if it is closed or under pre-load.
1.
Select the appropriate power crimp head with the proper tooling kit inserted for the application needed (The
crimp head and tooling kits are sold separately).
2.
Switch off the battery powered crimping tool and remove the battery.
3.
Install the desired crimping dies into the upper and lower crimp head components. See Figure 2.1.
4.
Slide out the locking pins on the Power Crimping Tool to allow for installation of the crimp head. Then, snap
the lower die holder into the mounting hole on the top of the crimping tool (dies not shown).
5.
Attach the upper portion of the crimp head to the Power Crimping Tool and slide the pins back through the
mating holes in the crimp head to secure it to the Power Crimping Tool. See Figure 2-2
6.
Check the crimp head to insure that the locking pins are fully inserted.
WARNING
:
Electric shock hazard:
This tool is not insulated. When using this unit near energized electrical lines, use proper personal
protective equipment.
Failure to observe this warning could result in severe injury or death
WARNING
:
Wear eye protection when operating or servicing this tool.
Failure to wear eye protection could result in serious eye injury from flying debris or hydraulic oil.
Install the Battery
1.
Insert the battery by aligning the grey latches on the top of the battery with the arrows on the mating end of the
crimping tool and then pushing upward.
2.
To lock the battery in place, slide it back until the latch locks it in place.
3.
When removing the battery, push the grey battery lock button while sliding the battery in the forward direction.
Figure2-1
DIES
CRIMP
HEAD
LOCKING
PINS
UPPER DIE
HOLDER
Figure 2-2
LOWER DIE
HOLDER
