Battery Powered Crimping Tool
Order No: TM-638161000
Release Date: 04-03-13
UNCONTROLLED COPY
Page 18 of 21
Revision: D
Revision Date: 12-16-15
CAUTIONS:
1.
Charging the battery at low temperatures under 5°C (41°F) is not possible. The battery temperature must be
warmed up before starting the battery cycle again.
2.
Do not expose the charging unit to rain or snow.
3.
Do not charge the battery in or around explosive materials or gases.
4.
Do not use any other (dry or car) battery with the charging unit or the crimping tool.
5.
Do not use the cord as a handle to carry the battery unit.
6.
Do not pull the cord out of a wall socket with force.
7.
Do not pull out the plug of the charging unit until after the battery has been charged.
8.
Do not insert foreign objects into the charging unit.
9.
Do not disassemble the charging unit.
10.
Do not place the battery in your pocket or a tool box, if there are conductive materials such as coins, keys,
tools or other metallic parts, they may cause injury or property damage.
4.3 Disposal
When this tool is no longer operating properly the different components of this tool will need to be disposed of
separately.
1.
The battery must be disposed of according to the Rechargeable Battery Recycling Corporation (RBRC) in the
USA, or other applicable guidelines in other countries.
2.
The remaining parts of this tool must be disposed of according to the domestic environmental standards or the
Environmental Protection Agency (EPA) in the USA, or other applicable guidelines in other countries.
3.
Because of possible environmental damage, we recommend disposal of the tool by a professional company.
Do not dispose of this tool in your residential or commercial waste, as it would be hazardous to the environment.
4.4 Warranty
All tools are warranted to be free of manufacturing defects for a period of 30 days. Should such a defect occur, we
will repair or exchange the tool free of charge. This repair or exchange will not be applicable to altered, misused,
or damaged tools. This tool is designed for hand use only. Any clamping, fixturing, or use of handle extensions
voids this warranty. After one year Molex recommends the crimping tool be returned to a Molex representative for
inspection. Only the heads of the crimping tool are permitted to be changed by the operator.
Do not damage the seals of this tool.
If seals are damaged the warranty is void.
CAUTION
: Molex crimp specifications are valid only when used with Molex terminals and tooling.
