Distributor of Molex Connector Corporation: Excellent Integrated System Limited
Datasheet of 0638236800 - HANDTOOL CRIMP 2.5MM BOARDIN PIN
Contact us: sales@integrated-circuit.com Website: www.integrated-circuit.com
Hand Crimp Tool For
2.50mm (.098") Board-In Connector, Mini. Crimp Pin
Doc No: ATS-638236800
Release Date: 10-25-10
UNCONTROLLED COPY
Page 3 of 7
Revision: A
Revision Date: 10-25-10
RELEASE
LOCATOR BUTTON
TERMINAL
Figure 3
LOCATOR
PUSHED THRU
TOOLING
TERMINAL
LOCATOR
BUTTON
PUSHED IN
LOCATOR
WIRE
TERMINAL
WIRE AGAINST
THE WIRE STOP
WIRE STOP IS PART OF
THE LOCATOR
Figure 5
PRE-STRIPPED
WIRE
TERMINAL
Crimping Terminals
1.
Select the desired terminal listed in the
preceding charts.
2.
Make sure the center of the locator is in the
down position. With the locator attached,
push the locator button on the back of the
hand tool to bring the locator forward through
the tooling. See Figure 2.
3.
While holding the locator button in, load the
terminal into the proper nest opening in the
locator based on the wire gauge or terminal
type markings on the hand tooling. See
Figure 3.
4.
Release the locator button, allowing the locator to return to the crimping
position.
5.
Close the tool handle until the first ratchet position engages. See Figure
4.
6.
Insert the properly stripped wire through the terminal and against the
wire stop. See Figure 5.
7.
Crimp the terminal by squeezing the tool handles until the ratchet
mechanism cycle has been completed. Release the handles to open the
jaws.
PARTIALLY
CLOSE HANDLE
TOOLING
PARTIALLY
CLOSED
Figure 4
FIRST RATCHET
POSITION
OPEN
POSITION
SQUEEZE
HANDLES
TOGETHER
HANDLE WILL
SPRING OPEN
Figure 1
LOCATOR
IN DOWN
POSTION
PUSH ON THE
LOCATOR BUTTON
Figure 2
4 / 8
4 / 8
