Hand Crimp Tool For
3.50 (.138”) Wire to Wire Connector, Crimp Pin
Doc No: ATS 638238700
Release Date: 07 13 11
Page 3 of 7
Revision: A
Revision Date: 07 13 11
+ /! %
+
+ /! 9
(
! ,
!,
-
1. Select the desired terminal listed in the
preceding charts.
2. Make sure the center of the locator is in the
down position. With the locator attached,
push the locator button on the back of the
hand tool to bring the locator forward through
the tooling. See Figure 2.
3. While holding the locator button in, load the
terminal into the proper nest opening in the
locator based on the wire gauge or terminal
type markings on the hand tooling. See
Figure 3.
4. Release the locator button, allowing the locator to return to the crimping
position.
5. Close the tool handle until the first ratchet position engages. See
Figure 4.
6. Insert the properly stripped wire through the terminal and against the
wire stop. See Figure 5.
7. Crimp the terminal by squeezing the tool handles until the ratchet
mechanism cycle has been completed. Release the handles to open
the jaws.
+ /! 4
+
:
;
+ /! 1
+ /! '
