Distributor of Molex Connector Corporation: Excellent Integrated System Limited
Datasheet of 0638259400 - HAND CRIMP TOOL
Contact us: sales@integrated-circuit.com Website: www.integrated-circuit.com
Hand Crimp Tool For Wire to Motor Crimp Terminals
Doc No: ATS-6382594HM
Release Date: 09-04-13
UNCONTROLLED COPY
Page 4 of 6
Revision: A
Revision Date: 09-04-13
INCORRECT
Figure 5
CORRECT
INCORRECT
3.
Insert the proper terminal fully into the correct profile slot
until the terminal is fully seated and stops. Then gently
pivot the locator closed.
4.
With hand pressure, slowly slide the locator to the correct
position. See Figure 5.
5.
Gently pivot the locator open without disturbing the
location.
6.
Hold the locator firmly in place and slowly tighten the M4
BHCS.
Maintenance
It is recommended that each operator of the tool be made aware of, and responsible for, the following
maintenance steps:
1.
Remove dust, moisture, and other contaminants with a clean brush, or soft, lint free cloth.
2.
Do not use any abrasive materials that could damage the tool.
3.
Make certain all pins; pivot points and bearing surfaces are protected with a thin coat of high quality machine
oil. Do not oil excessively. The tool was engineered for durability but like any other equipment it needs
cleaning and lubrication for a maximum service life of trouble free crimping. Light oil (such as 30 weight
automotive oil) used at the oil points, every 5,000 crimps or 3 months, will significantly enhance the tool life.
4.
Wipe excess oil from hand tool, particularly from crimping area. Oil transferred from the crimping area onto
certain terminations may affect the electrical characteristics of an application.
5.
When tool is not in use, keep the handles closed to prevent objects from becoming lodged in the crimping dies,
and store the tool in a clean, dry area.
Miscrimps or Jams
Should this tool ever become stuck or jammed in a partially closed position,
Do Not
force the handles
open or
closed
. The tool will open easily by lifting the ratchet release lever. See Figure 9.
Warranty
This tool is for electrical terminal crimping purposes only. This tool is made of the best quality materials. All vital
components are long life tested. All tools are warranted to be free of manufacturing defects for a period of 30
days. Should such a defect occur, we will repair or exchange the tool free of charge. This repair or exchange will
not be applicable to altered, misused, or damaged tools. This tool is designed for hand use only. Any clamping,
fixturing, or use of handle extensions voids this warranty.
CAUTION:
Repetitive use of this tool should be avoided.
CAUTIONS:
1.
Manually powered hand tools are intended for low volume or field repair. This tool is
NOT
intended for
production use. Repetitive use of this tool should be avoided.
2.
Insulated rubber handles are not protection against electrical shock.
3.
Wear eye protection at all times.
4.
Use only the Molex terminals specified for crimping with this tool.
5 / 7
5 / 7
