Hand Crimp Tool for Ditto Wing Genderless Interconnects Terminals
Doc No: ATS-638278600
Release Date: 09-29-15
UNCONTROLLED COPY
Page 6 of 8
Revision: B
Revision Date: 08-20-19
Miscrimps or Jams
Should this tool ever become stuck or jammed in a partially closed
position,
Do Not
force the handles open or closed.
The tool will open
easily by pressing up on the ratchet release lever in the movable
handle. See Figure 11.
How to Adjust Tool Preload (See Figure 12)
This hand tool is factory preset to 25-45 pounds handle preload. It may be necessary over the life
of the tool to adjust tool handle preload force. Listed below are the steps required to adjust the
crimping force of the hand tool to obtain proper crimp conditions:
1.
Hold the hand tool in the palm
of your hand as shown in
Figure 12. Using your index
finger, squeeze the link toward
the top of the hand tool frame.
This will release the preload
adjustment wheel.
2.
Rotate the setting wheel
counterclockwise (CCW) to
increase handle force. The
numbers will display higher. To
decrease handle force, rotate
the setting wheel clockwise
(CW).
3.
Release the link to lock the
setting wheel in place.
4.
Check the crimp specifications
or conduct a pull test after tool
handle preload force is adjusted.
Warranty
This tool is for electrical terminal crimping purposes only. This tool is made of the best quality
materials. All vital components are long-life tested. All tools are warranted to be free of
manufacturing defects for a period of 30 days. Should such a defect occur, Molex will repair or
exchange the tool free of charge. This repair or exchange will not be applicable to altered, misused
or damaged tools. This tool is designed for hand use only. Any clamping, fixturing or use of handle
extensions voids this warranty.
CAUTION:
Molex crimp specifications are valid only when used with Molex terminals and
tooling.
CAUTIONS:
1.
Manually powered hand tools are intended for low-volume use or field repair. This tool is
NOT
intended for production use. Repetitive use of this tool should be avoided.
2.
Insulated rubber handles are not protection against electrical shock.
3.
Wear eye protection at all times.
4.
Use only the Molex terminals specified for crimping with this tool.
RATCHET RELEASE
LEVER
Figure 11
Figure 12
SQUEEZE
THE LINK IN
THE HANDLE
HOLD THE HAND
TOOL IN POSITION
SETTING
WHEEL
RATCHET
RELEASE LEVER