Distributor of Molex Connector Corporation: Excellent Integrated System Limited
Datasheet of 0640054100 - AT-FIFG CRIMP TOOL HEAD
Contact us: sales@integrated-circuit.com Website: www.integrated-circuit.com
AT-FIFG Air Head Crimp Tool
Doc No. 64005-4100 Release Date: 09-22-03
UNCONTROLLED COPY
Page 2 of 6
Revision: A
Revision Date: 09-22-03
TERMINA
WIRE
CONDUCTO
R
Figure 3
CONDUCTO
R
WIRE
TERMINAL
Figure 2
JAWS
OPEN
SAFETY
SHIELD
LOCATOR
Operation
Refer to the instruction manual for the 19279-0001 (AT-200) for
mounting this crimp tool head.
Crimping Terminals
1. Place the flag terminal barrel into the conductor anvil of the
lower jaw. Make sure the closed end of the barrel is touching
the locator. (See Figure 1).
Caution: Never operate this tool without the supplied safety shield in place. Never place
fingers in the tool nests.
2. Insert the properly stripped wire into the terminal barrel, (See figure 3).
3. Push on the wire to assure it is fully seated in the terminal (See Figure 2 and 3). Cycle the tool.
4. Remove the crimped terminal. Inspect for proper
crimp.
Maintenance
It is recommended that each operator of the tool be made
aware of, and responsible for, the following maintenance
steps:
1.
Remove dust, moisture and other contaminants with a
clean brush, or soft, lint-free cloth.
2.
Do not use any abrasive materials that could damage
the tool.
3.
Make certain all pins; pivot points and bearing
surfaces are protected with a thin coat of high quality
machine oil. Do not oil excessively. The 64005-4100 (AT-FIFG) was engineered for durability, but
like any fine piece of equipment it needs cleaning and lubrication for a maximum service life of
trouble-free crimping. A light oil, such as 30 weight automotive oil used at the oil points shown in
Figure 4, every 5,000 crimps or monthly will significantly enhance the tool life and ensure a stable
calibration.
4.
When tool is not in use store the tool in a clean, dry area.
LUBRICATION
POINTS
(BOTH SIDES)
LIGHT OIL
Figure 4
Figure 1
LOCATO
TERMINA
3 / 7
3 / 7
