AT-1991 Air Head Crimp Tool
Doc. No. 64005-0200
Release Date: 09-20-02
UNCONTROLLED COPY
Page 4 of 7
Revision: D
Revision Date:05-27-05
Tool Calibration
A Certificate of Calibration (see last page) was
supplied with the tool. To recalibrate this tool, pin
gauge measurements should be taken in each
conductor nest and compared to this chart. The tool
should be lubricated prior to recalibration to ensure
consistent measurements.
Wire Range
“X” DimensionConductor Crimp
Nest Color Code
AWG mm²
Mean
Go
No Go
Crimp Inspection
Marking
Red
18 - 22 0.35 - 0.80
.069
.066
.072
oo
Blue
14 - 16 1.30 - 2.00
.092
.089
.095
o
Yellow
10 - 12 3.30 - 5.00
.100
.097
.103
oo
Warranty
This tool is for electrical terminal crimping purposes only. This tool is made of the best quality materials. All vital
components are long-life tested. All tools are warranted to be free of manufacturing defects for a period of 30
days. Should such a defect occur, we would repair or exchange the tool free of charge. This repair or
exchange will not be applicable to altered, misused or damaged tools.
PIN GAUGE IN
CONDUCTOR CRIMP
“Confining” Crimp
X
