AT-200 Air-Powered Crimping Tool
Doc No: TM-192790001
Release Date: 07-01-02
UNCONTROLLED COPY
Page 3 of 20
Revision: G
Revision Date: 01-17-14
WARNING
WARNING
Never
use this machine without guards or safety
devices that are intended
to prevent hands from remaining in the die space.
Failure to observe this warning could result in
Severe injury or death.
Do not use
compressed air to clean
this equipment.
The forces created by compressed
air can force debris into the tool.
Failure to observe these precautions may
result in injury or property damage.
WARNING
Always
wear proper ear protection when Operating or servicing this equipment.
CAUTION
The Molex at-200 air powered crimping tool is designed to be used with air powered crimp tools heads and tooling supplied by Molex.
Use of tool heads or tooling from any other source may result in damage or injury.
Molex will not be liable for any damage or injury from use of non-Molex components in this tool.
CAUTION
Never
perform any service or maintenance other than as described in this manual.
Never
modify, alter or misuse this tool
Molex crimp specifications are valid only when used with Molex terminals, applicators and tooling.
Failure to observe this precaution may result in injury and property damage.
Tooling Technical Assistance
Molex offers tooling technical assistance for customers who may need some guidance for tooling adjustments. This
support can be obtained by calling either of the two numbers listed below and asking for the Molex Tooling Group.
Call Toll Free 1-800-786-6539 (US) 1-630-969-4550 (Global).
This assistance is limited to the operation and set-up of a customer’s tool. Questions with regard to Molex connector
products or how to identify the proper tooling and/ or tooling documentation should be directed to your local Molex
personnel or Customer Service Representative.
When calling for service on the press a copy of the
Operation Manual
and Specific
Applicator Tooling Specification
Sheet
should be present and a person that is familiar with the applicator should be present. Be sure the following
information is supplied:
1.
Customer name
2.
Customer address
3.
Person to contact such as (name, title, e-mail, and telephone number
4.
Applicator order number (Lease number also if applicable)
5.
Serial number (Lease number also if applicable)
6.
Molex Connector product order number
7.
Urgency of request
8.
Nature of problem
Molex Application Tooling Group
2200 Wellington Court
Lisle, IL 60532, USA
Tel: +1 (630) 969-4550
Fax:+1 (630) 505-0049
Visit our Web site at http://www.molex.com