AT2080 Air Crimp Tool Head
Doc No: ATS-640052500
Release Date: 01-20-03
UNCONTROLLED COPY
Page 7 of 7
Revision: C
Revision Date: 06-23-21
Certificate of Calibration
Tool Order Number: ___________________
Tool Eng. Number: ___________________
Tool Revision: ___________________
Serial Number: ___________________
Date of Manufacture: ___________________
Handle Load Range at 1 inch from the Tips = ________________
Actual = ________________
Pin Gauge of Conductor Nest/Nests or Slug height if the nest is the “F” Crimp style.
Range Conductor Nest # 1 = ____________ — Actual = ______________
Range Conductor Nest # 2 = ____________ — Actual = ______________
Range Conductor Nest # 3 = ____________ — Actual = ______________
Technician: ______________
Date of Calibration: ______________
Calibration should be done every 5,000 cycles or every 3 months. Tools should be lubricated during
this operation.
Application Tooling Support
Phone: (402) 458-TOOL (8665)
E-Mail: applicationtooling@molex.com
Website: www.molex.com/applicationtooling
Molex is a registered trademark of Molex, LLC in the United States of America and may be registered in other countries; all other
trademarks listed herein belong to their respective owners.
Order Number
64005-2500
Engineering No.
AT 2080
