AT-2212 Air Crimp Tool Head
Doc No: ATS-640053600
Release Date: 06-24-03
UNCONTROLLED COPY
Page 5 of 8
Revision: B
Revision Date: 09-30-05
Tool Calibration
A Certificate of Calibration (see last page) was supplied with the
tool. To recalibrate this tool, pin gauge measurements should be
taken in each conductor nest and compared to this chart. The tool
should be lubricated prior to recalibration to ensure consistent
measurements.
Wire Range
“X” DimensionConductor Crimp
AWG
mm²
Mean
Go
No Go
12 - 22 0.35 – 3.30
.102
.099
.106
Warranty
This tool is for electrical terminal crimping purposes only. This tool is made of the best quality materials. All vital
components are long-life tested. All tools are warranted to be free of manufacturing defects for a period of
30 days.
Should such a defect occur, we would repair or exchange the tool free of charge. This repair or exchange will not
be applicable to alter, misused or damaged tools.
CAUTION
: Molex crimp specifications are valid only when used with Molex terminals, applicators and tooling.
PIN GAUGE IN
CONDUCTOR CRIMP
“ Confining ” Crimp
X
