MagKrimp™ Hydraulic Head Crimper
Doc No. TM-190780422
Release Date: 03-28-14
UNCONTROLLED COPY
Page 18 of 22
Revision: A
Revision Date: 03-28-14
Preventive Maintenance Chart
Daily:
Clean. See Section 5.8.
As Required:
Lubricate. See Section 5.1.
CHECK SHEET MONTH YEAR _________
Week
Daily
Use
Days of the Week
Solution
MON
TUE
WED
THU
FRI
SAT
SUN
1
2
3
4
Lubrication
1 drop per minute
into the system
Use SAE No. 10 Oil
Change Hydraulic
Oil
300 Hours
Use OTC 16355
Bleeding Air From
the System
After prolong use
Run the system thru
several cycles.
Refilling Reservoir
10 hours or when needed
Use 215 SSU@100
°
F
(OTC 16355)
Cleaning
Hose connections free of grit
and dirt. Pump kept clean
Use soft cloth
Schedule should be adjusted up or down depending on usage. Molex recommends that a log of preventive
maintenance be kept with the tool.
4.9
Spare Parts
Customers are responsible for maintaining the tool. Spare parts are available from Molex. Moving and
functioning parts can be damaged or wear out over time and will require replacement. Molex recommends that
the customer keep some or all of them in stock to reduce production down time.
4.10 Perishable Parts (Tool Kits)
Customers are responsible for maintaining the tooling kits used in the 19078-0422. Perishable parts are
those parts that come in contact with the product and will wear out over time. Molex recommends that all
customers keep at least one set of the perishable tooling in stock at all times. This will reduce the amount of
production down time.
4.11 Storage
When storing the 19078-0422 assembly, disconnect the air supply and store in a dry location. If the pump is
disconnected from the hydraulic head, reinstall the dust cap on the cylinder inlet. When transporting, reinstall
the red-filler cap on the pump reservoir.
