PRODUCT APPLICATION SPECIFICATION
THIS DOCUMENT CONTAINS INFORMATION THAT IS PROPRIETARY TO MOLEX ELECTRONIC TECHNOLOGIES, LLC AND SHOULD NOT BE USED WITHOUT WRITTEN PERMISSION
REVISION
DESCRIPTION
REVISED
APPLICATION SPECIFICATION FOR
MICRO-LOCK PLUS 2.0 SINGLE ROW
CHANGE NO.
682239
REVISED BY
SOKUMURA01
DATE
2021/02/09
DOC TYPE
DOC TYPE DESCRIPTION
DOC PART
SERIES
REV APPR BY AIDA
DATE
2022/06/30
PS
APPLICATION SPECIFICATION WORD
A03
505570
INITIAL RELEASE
CUSTOMER
DOCUMENT NUMBER
REVISION
SHEET
INITIAL DRWN KUSATO
DATE
2016/04/20
GENERAL MARKET
5055700001
E
15
OF
49
INITIAL APPR
TKANEKO
DATE
2016/04/21
PROCEDURE: 2090580010-ES TEMPLATE: 2090580010-PAS-A4 REVISION: A1
4.
After inserting the terminal, please confirm if terminals are not pulled out from receptacle housing by pulling
wires lightly (with about 100g force)
(Confirmation by excessive tension might break connector.)
5.
After inserting all terminals, please confirm the position of terminal lance part by looking through window of
receptacle mold lance. If they are inserted correctly, terminal lance is at the position where terminal lance
rode up mold lance properly and you can confirm clearance by shaking them axially lightly.
(Fig.6-4,6-5)
※
If they are inserted correctly, terminal lance is at the position where terminal lance rode up mold lance
properly and you can confirm clearance by shaking them axially lightly.
※
If terminal is inserted incompletely, terminal lance is not locked with mold lance and terminal is not retained.
※
In the area of incomplete insertion (see
Fig.6-5
), terminal lance is transformed the most.
(Therefore, mold lance of harness with such condition is transformed and not go back to correct position,
resulting in degradation of retention force even though it is re-inserted.) In this case, please be sure to
change with a new terminal.
〇
×
Terminal has reached the end
Terminal has not reached the end
Fig.6-4 The case of correct insertion
Fig.6-5 The case of incomplete insertion
As not being inserted
completely, mold lance
is not locked.
Mold lance rode
up completely.
Instruction
Good
No Good
