RHT-5771 Hand Crimp Tool
Doc No. 64001-4500
Release Date: 11-06-03
UNCONTROLLED COPY
Page 6 of 6
Revision: B
Revision Date: 07-05-06
Certificate of Calibration
Tool Order Number ____________________________
Tool Eng. Number_____________________________
Tool Revision________________________________
Serial Number_______________________________
Date of Manufacture___________________________
Handle Load Range at 1 inch from the Tips =_______________
Actual =_______________
Pin Gage of Conductor Nest/Nests or Slug height if the nest is the “F” Crimp style.
Range Conductor Nest # 1 =______________Actual =_____________
Range Conductor Nest # 2 =______________Actual =_____________
Range Conductor Nest # 3 =______________Actual =_____________
Technician________________________
Date of Calibration ___________________
Calibration should be done every 5,000 cycles or 3 months.
Tools should be lubricated during this operation.
Americas Headquarters
-JTMF*MMJOPJT64"
.0-&9
BNFSJOGP!NPMFYDPN
Far East North Headquarters
:BNBUP,BQBO
GFOJOGP!NPMFYDPN
Far East South Headquarters
+VSPOH4JOHBQPSF
GFTJOGP!NPMFYDPN
European Headquarters
.VOJDI(FSNBOZ
FVSJOGP!NPMFYDPN
Corporate Headquarters
8FMMJOHUPO$U
-JTMF*-64"
'BY
Visit our Web site at http://www.molex.com