Hand Crimp Tool for Krimptite
/ VersaKrimp
Terminals
Doc No: ATS-640160038
Release Date: 06-27-12
UNCONTROLLED COPY
Page 5 of 5
Revision: A
Revision Date: 06-27-12
CAUTION
: Molex crimp specifications are valid only when used with Molex terminals and tooling.
CAUTIONS:
1.
Manually powered hand tools are intended for low volume or field repair. This tool is
NOT
intended for
production use. Repetitive use of this tool should be avoided.
2.
Insulated rubber handles are not protection against electrical shock.
NEVER
perform crimps on active
electrical circuits.
3.
Wear eye protection at all times.
4.
Use only the Molex terminals specified for crimping with this tool.
Certification
Molex does not certify or re-certify ServiceGrade™ hand tools but rather supplies the following guidelines for
customers to maintain their hand tools.
%
This tool is qualified to pull force only. To re-certify, crimp a terminal to a wire, which has been stripped
12.7mm (1/2”) long, so there is no crimping of the insulation. Pull the terminal and wire at a rate no faster than
25mm (1.00”) per minute. See the Molex web site for the Quality Crimp Handbook for more information on pull
testing.
%
When the hand tool is no longer capable of achieving minimum pull force, it should be replaced.
Visit our Web site at http://www.molex.com
