Molok Oy Nosturikatu 16 37150 Nokia, Finland Tel. +358 10 3429 400 molok@molok.com www.molok.com
DEEP C
OLLECTION
®
9/
20
16
/M
TJ © M
o
lo
k O
y
1. ANCHORING THE CONTAINER TO DRY OR SLIGHTLY MOIST SOIL
Make sure that the soil type has proper water drainage; such soil types are for example silt, grit and moraine.
Install the containers according to the given instructions. If the soil type seems to have poor drainage, or if the
installation pit collects surface water, consider installing the containers according to point 3 below.
2. INSTALLING THE CONTAINER TO WET SOIL OR SOIL WITH CLAY
Use filter cloth between the ballast and gravel and if necessary also under the crushed gravel on the bottom of the
pit. Make sure there is enough fabric also for the sides of the pit.
Fasten the bottom anchors according to instructions on first page.
Install a plywood plate (# 15 mm, 820x300 mm) as an extra anchor between every bottom anchor. Install the ply-
wood on top of the bottom anchors in a way that the center of the plate touches the container on the inside and is
in level with the bottom anchors on the outside. Fasten the plywood plate by
screwing it from both ends to the bottom anchors, for example with 4x40 mm screws.
If necessary, use a drain pipe on the bottom of the installation pit under the Crushed gravel.
Finish the installation according the instructions above.
3. INSTALLING TO A VERY WET SOIL
Start the installation according to poits 1-3 on the first page
Begin filling with crushed gravel, for example 0/16 mm.
Cast 15 cm ready-mixed concrete (for example K30, #16 mm, S3) on the gravel, and around the container.
Make sure that the container does not move during concreting. Finish the filling according to given
instructions.
If necessary, use a drain pipe on the bottom of the installation pit under the Crushed gravel.
