water systems —
13
2 0 0 8 l a Pa l m a X l
System Heat Operation (Optional)
1. Systems heat switch is turned
ON
to apply power to the snap
disc thermostat.
2. When the bay
temperature reaches 40º
F (+/-6º F) the snap disc
thermostat closes. The
bay heater and systems
heat Active light turns
on. The heater continues
to operate until bay temperature
reaches 55º F (=/-6º F). The bay heater
and Active indicator light will turn
OFF
.
NOTE:
The bay heater consumes about 20
Amps when operating. House battery
power can be quickly consumed. It is
recommended to hook shore power when
using Systems Heat.
Cold Weather Storage
If the motorhome is stored where freezing
temperatures may occur, drain the domestic fresh
water loop. Begin draining the fresh water tank
by opening the low point drain for the fresh tank
and allowing the water to drain.
NOTE:
Icemakers, water filters, water purifiers
and water heaters all use domestic water
and should be drained and stored in
accordance with the manufacturer’s
recommendation for winterization.
WInterIzatIon
Water, plumbing and sewer systems require
winterization when the motorhome is placed
in storage. The recommended method of
winterizing the motorhome is using air pressure
to remove liquids that may freeze and cause
damage to the various systems and appliances.
The lines can then be left empty or filled with an
FDA approved RV antifreeze. When plumbing
lines are drained, antifreeze is not necessary,
and the decision to use antifreeze is left to the
motorhome operator.
NOTE:
ONLY FDA approved RV antifreeze
should be used to winterize the water
systems in the motorhome.
Using Air Pressure
Access to an air compressor, and an adapter
to connect the air line regulator to the water
system, is necessary. Air adapters used for
winterizing are available at RV supply locations.
Air pressure should not exceed 40 PSI. Higher
pressure can damage the water lines.
WARNING:
It is recommended that a qualified
RV service technician familiar with
motorhomes, such as an authorized
dealer, perform the winterization
procedure.
NOTE:
Freeze damage is not covered under
warranty.
1. Empty and flush the holding tanks.
2. Disconnect the water line connections
on either side of the water filter bowl
head. Connect the bypass hose to
the water lines. Unscrew filter bowl,
remove old cartridge and empty any
remaining water in the bowl.
DO NOT
screw filter bowl back onto filter head
(see “Water Filter”).
3. Drain the fresh water tank by opening
the fresh water tank drain valve and
the fresh water tank low point drain
valve. Both are located in a curbside
compartment.
4. Open hot and cold low point drain
valves, fresh water tank line drain valve
and winterization valve. All are located
in the water service center.
CAUTION:
Some appliances, such as the washer/
dryer and ice maker, require special
winterizing instructions not covered in
this section (due to the wide variety of
manufacturers and models). Refer to
the specific appliance OEM manual for
instructions and recommendations.
030981d
040437
040614c
Fresh Water System Drains
Summary of Contents for 2008 LaPalma XL
