19
2 0 0 8 l a Pa l m a X l
electrIcal systems- chassIs — 9
PATIO AWNING ON/OFF (Optional):
Provides power to the patio awning. Turn on for
interior and exterior awning switches to operate.
PATIO AWNING EXTEND/
RETRACT (Optional):
Extends and retracts the patio awning.
NOTE:
See Section five for more information.
Passenger Console
STEP COVER:
Extends and retracts the step
cover.
STEP LIGHT:
Provides power to the exterior
amber step light.
MAP LIGHT:
Turns on and off map light.
Battery cut out switch must be on for map light
to operate.
PASS SHADE:
Operates the power sun visor
located on passenger side.
Dash
HEADLIGHT:
Pull one click
to operate the parking lights.
Pull two clicks to operate
the headlights. Rotating the
headlight switch clockwise will
dim the dash lights. Rotating the
headlight switch counterclockwise illuminates
the dash lights.
DRIVER MAP LIGHT:
Above the driver is a
map light. To turn ON, rotate headlight switch
counterclockwise. To turn OFF, rotate switch
clockwise. The battery Cut-Out switch must be
on for map light to operate. The map light is not
dimmable.
NOTE:
If the headlights are left ON and
the ignition turned OFF a warning
bell sounds alerting the driver that
headlights are still ON.
WIPER/WASHER:
Wiper
operations are controlled when
rotating the knob to the right.
When the knob is rotated from
OFF
to
DELAY
, the wiper will
turn on and time delay between
wipes (ranging from 45 seconds to two seconds)
will occur. The amount of delay time changes
as knob is rotated. A continuous low or high
speed can be obtained by rotating the knob to the
appropriate position. The wipers will be turned
OFF
with the switch in the
OFF
position. When
the end of the knob is pushed in, washer fluid
will dispense from the system and the wipers
will turn on momentarily.
Controls
TRANSMISSION SHIFTER:
The Allison
1000 series transmission is a fully automatic,
torque-converter driven, electronically controlled
transmission. The electronic shift control
provides automatic gear selection in all drive
ranges and automatic engagement of the torque
converter lockup clutch.
MIRROR ADJUST:
To adjust the rear view
mirror the small selector in the middle of the
switch must be placed in the desired side.
The middle position is to prevent accidental
bumping of the switch and changing of the
mirror position. The outside mirrors have been
placed so that they can be easily adjusted with
the Allen wrench. After taking delivery of the
new motorhome it will be necessary to sit in the
driver’s seat and adjust the mirrors to driver’s
needs. Both the driver and the passenger mirrors
should be adjusted.
Power Gear Control -
Hydraulic Systems:
The three-point hydraulic leveling system is
operated from the control module to manually or
automatically level the motorhome. The control
features a multiple warning system with flashing
lights and an alarm to alert of a jack down.
BACKUP MONITOR:
Used with the back
up camera and will display the rear view of the
motorhome.
080332
031204c
080339b
Summary of Contents for 2008 LaPalma XL
